Home » Indoor Air Quality » Greentek » Accessories » Airflow Grid
Airflow Grid
Airflow Grid

Installation

  • The airflow-monitoring grid should be located at a minimum of 18" after and before any source of turbulence such as a motor, an elbow, a change of diameter, etc.
  • For a greater accuracy, the distance should be increased.
  • These airflow-monitoring grids should only be used on round rigid duct.
  • A one-inch hole should be drilled where the grid is going to be installed.
  • Two sheet metal screws should be used to hold the grid in place.
  • Two 3/16 inch inside diameter hoses should be used to connect the grid to the pressure differential gauge.
  • A chart is provided on each grid for converting inches of water to cubic feet per minute (CFM) and liters per second (L/S).
Accessories()
+
-
Wall Controls
• Filters
• Matrix Hood
• Airflow Grid
Downloads
Home Owners Guide Home Owners Guide 3.23 MB
Termes de Garantie Termes de Garantie 0.12 MB
Warranty Terms Warranty Terms 0.12 MB
Buy your Filters NOW!
Frequently Asked Questions
Certified products and/or proud member of these associations
Imperial Group
Head Office & Customer Service
1.800.561.3100
Stay
connected
Home
Company
Opportunities
Contact us
Site Map
Support
Awards & Accolades
In the Community
What's New?
Upcoming Events
Registers & Grilles
Venting & Flexible Duct
Stove
Fireplace
Greentek
Imperial Air Technologies
Railing, Columns & Fencing
Galvanized Duct, Pipe & Fittings
Steel Stud, Channel & Trim
Air Filtration
© 2017 Imperial Manufacturing Group|All rights reserved|A NuFocus Online Solution
Content Support
E-mail Now